Service sizing
A load calculation that sets the service and panel size for the house as designed, plus sensible room to grow.
New Construction
New Construction Wiring in Hunts Point
New homes, ADUs and large additions wired from service entrance to final fixture, on schedule and inspected at every stage.
Discuss your build — (000) 000-0000
Wiring a House From the Ground Up
New construction is the one time every wire can go exactly where it should. It is also when decisions about service size, charger readiness and lighting control are cheapest to make.
Electrician Hunts Point works with owners and general contractors on new homes, accessory dwelling units and major additions. We size the service from a load calculation, lay out every circuit with you, and plan for what is coming, such as an EV charger in the garage or a heat pump on the side yard. Then we rough in, pass inspection and finish on the builder's schedule.
What New Construction Wiring Includes
One electrical partner from the first plan to the final sign-off.
Electrical layout
Outlet, switch, lighting and appliance locations planned room by room and agreed in writing.
Temporary power
Construction power arranged early so other trades can start on time.
Rough-in
Boxes, cable and low-voltage pathways installed once framing is ready, neatly stapled and protected.
Charger and heat pump readiness
Circuits or conduit placed now for the equipment you plan to add later.
Lighting plan
Recessed, pendant and exterior lighting positioned with switching that makes sense for how you will use each room.
Inspections at each stage
Rough-in and final inspections booked ahead so the schedule does not slip.
Finish and documentation
Devices and fixtures installed, every circuit tested and a full panel directory handed over.
How We Work With Your Builder
Plan review
We review the drawings, run the load calculation and produce a written electrical scope and price that your contractor can schedule around.
Rough-in and inspection
When framing is ready we rough in the whole house, usually over a few days, then call for inspection before insulation.
Finish and final
After drywall and paint we set devices and fixtures, energize and test every circuit, and pass the final inspection.
Why Builders Bring Us On
We show up when framing is ready
Rough-in is scheduled with the contractor, not squeezed in around other work.
Future-ready by default
We ask about chargers and heat pumps before the walls close, so the circuits are there when you need them.
Clear paperwork
Scope, load calculation and panel directory are all in writing for the owner's records.
- Load-calculated serviceSized to the design.
- Staged inspectionsBooked ahead.
- Builder coordinationOn the GC's timeline.
- Full directoryHanded over at the end.
Building Near Hunts Point?
Send us into the project early. A plan review and a written electrical scope make the rest of the build easier to schedule.
Talk about your build — (000) 000-0000