EV Charger Installation
Garage or driveway, hardwired or plug-in: we size the circuit to the charger and the panel, file the permit and test the charge rate on the day.
Read the detailsPermits pulled and inspections booked on every install · (000) 000-0000
Services
Chargers, panels, remodel circuits, rewiring and repairs, each one scoped in writing after we have seen your panel.
Ask which service fits — (000) 000-0000
Most calls start with a single job: a charger for a new car, a kitchen that needs more circuits, a breaker that will not stay on. Often the right answer touches two or three of the services below, which is why every visit begins with a look at the whole panel rather than just the outlet in question.
Each page explains what the work includes, how long it usually takes and what you will see on the day. If you are not sure which one describes your situation, call and describe it; we will point you to the right one.
Every service is permitted where the code calls for it and tested before we leave.
Garage or driveway, hardwired or plug-in: we size the circuit to the charger and the panel, file the permit and test the charge rate on the day.
Read the details
We work alongside your builder or designer: circuit plan, rough-in, inspection and finish, so the remodel passes the first time.
Read the details
A staged plan that replaces outdated wiring, adds grounding and modern protection, and keeps your house livable while we work.
Read the details
A single-purpose circuit sized to the appliance, run cleanly from the panel and tested under load before we leave.
Read the details
Priority visits for dangerous or disruptive faults during business hours, with safety steps you can take while we are on the way.
Read the details
From swapping a Federal Pacific or Zinsco panel to moving up to 200 amps, coordinated with the utility and inspected.
Read the details
Service sizing, rough-in, inspections and finish for new homes and accessory dwellings, coordinated with your general contractor.
Read the details
New fixtures, LED retrofits and lighting controls, planned with you and installed with clean ceiling cuts and matched dimmers.
Read the details
Methodical testing that finds the loose connection, failing device or overloaded circuit behind the symptom, with the fix priced before we do it.
Read the detailsWe compare what you want to add with what your service can carry, so the quote fits your house instead of a worst case.
Tasks, materials, permit and inspection are listed in one document with one total that does not drift.
Every new circuit is tested under load, labelled in the panel and walked through with you before we pack up.
Describe the problem or the project and we will tell you which kind of visit it calls for. The in-home estimate is free.
Describe the job — (000) 000-0000Hunts Point, the Points communities and the east shore of Lake Washington.